setting up a fuji xt-20 and a xt-2 with nikon flashes
I just bought 3 v6 11's and downloaded all the new firmware. fuj.1.002 together with the 3.0 for the xt-2 and 1.10 for the xt-20, both of which were released within the past 2 weeks. I have read the manual, watched utube videos and seem only able to do simple one power shots sometimes and power adjustments at other times.
So....I'm going to work my way through each camera with all of your help so I can start shooting. I was comfortable with nikon's speedlights when I shot Nikon cameras. However, now that I shoot fuji, I have a new learning curve.
first, let me check if I have somethings correct
1. there is no learning set up for high speed sync in the latest version of cactus software.
2. When I shot Nikon I always shot portraits in manual mode adjusting power for the different flash groups within the camera. Moving subjects I used ttl.
I'm unsure if everything should stay in ttl and I would adjust the power on the back of the tx cactus.
so camera ttl and flash units ttl?
let me start with this and work from there.
hopefully this discussion will help others with nikon flashes and fuji cameras
thanks in advance