Is V6 compatible with studio flash set QIHE BJ 150?

... or any other QIHE flash ...


  • Yes.

    The V6 is compatible with any strobe that has a sync-connector.
    You'd need a sync-cable between a V6 receiver and the strobe to connect them up. This cable does not come with a V6 but can be cheaply obtained.

    Note, however, that this will only allow you to trigger the strobe. You won't be able to remote control the power of the strobe. Remote power control only works with supported flashguns.
  • edited July 2015 PM
    This is the cable you will need for connecting a V6 (set to RX) to a studio strobe. Most of the strobes has a 3.5mm or 6.35mm sync port:

    Antonio Lao
    Brand Manager

    To help us better help you, always state the exact firmware version installed on your Cactus device(s), such as: "1.1.013", "FUJ.1.002", "v.103".

    For the time being, Cactus V6 (MK1) running on firmware version 2.1.001 can be triggered by a V6 II (MK2) running on Multi-brand HSS firmware (e.g. 1.1.013) and not by X-TTL firmware versions: PEN.A.001 and OLY.A.001.  No schedule has been released yet. 

    Cactus RF60X / RF60 Firmware versions A01 and A02 currently ONLY works with PEN.A.001 and OLY.A.001.  Other "A" version of X-TTL firmware will be released soon. For both Multi-brand HSS and X-TTL firmware versions (FUJ, SIG, SON), install firmware version 103 / 205 on your RF60X / RF60.

    Cactus RF60 is now an off-camera TTL flash with firmware version 205 or later!

    Metz M400 (for Fujifilm) is now supported on the Cactus V6 II (HSS and TTL).

    Nikon D750 users please read this thread: 

    Fujifilm EF-X500 users please read this thread:

    Feel free to suggest an improvement or share product ideas. Contact us directly at  At Cactus, we listen. 
Sign In or Register to comment.