firmware updater ..not working

ranter

i continue to get this message
regarding missing libusb0.dll file .. tried on 2 differnt laptops , one is running windows10 the ohter windows 7..
is this a know issue..
i am unable to upgrade firmware

raychan

Have you tried following these steps?

http://www.cactus-image.com/community/discussion/855/how-to-install-and-update-firmware-on-windows-8-and-windows-10

All the best,

ranter

thanks for that link.. no i did not see that  before

ronron

it works like charms!!!! thanks

ranter

So,, I tried it .. unfortunately StI'll getting the same messge.. I repeated the process multiple tim3s and not working

Antonio

So,, I tried it .. unfortunately StI'll getting the same messge.. I repeated the process multiple tim3s and not working

Try uninstalling it first, restart Windows, then do the Digital Signature trick and install the Updater program.  The USB driver (the DLL file) will then be installed correctly.

Have a go and see if it works.

Thank you!

pogzz505

Hi how can we check the firmware of the V6II?

I read somewhere here on how to check the RF60 by holding the NEXT button while turning ON the flash.
On the V6II I kinda tried to figure it out by holding the MENU button while turning on the V6II RX but the red light only blinked continuously so I just turned it off and didn't attempt to try again.

pogzz505

I found it...it's the same as the V6

Antonio

I found it...it's the same as the V6

Glad you found it.

I am trying to convince management to add a menu page to show the current firmware version instead of using this combo as the only method, which I recently found out a few of the Fujifilm cameras uses a similar trick too; it's not very ergonomic tbh.

ranter

so i updated ,, finally , had to use GF's macbook to do it .. i was never able to use my laptops

ranter

transcievers seem more stable .. however Hss still not working properly