Fuji XT-1 and Fuji EF-42 Flash
I have just purchased the Cactus V6 II triggers and have sort of successfully set up trigger and receiver. However, my problem is that although it appears that power levels when adjusted on the TX trigger, and appear to be updated the RX with the EF-42 flash, the actual power level used by the flash does not change. That is, it appears to be shooting at full power even though the RX and TX displays show 1/128. The manuals really are not all that clear to me.
Is there someone please able to provide with step by step instructions on how to correctly set up the Cactus triggers so I can vary the power from my on camera TX trigger. Thank you.
Comments
On the Quick Start Guide second page (under side) you will find step by step start up, plus a section on setting up Fujifilm.
Click here to view the Quick Start Guide online.
In the meantime please check if both the V6 II transceivers are set to the same channel (e.g. CH 12) and group (e.g. Group
Thanks!
Brand Manager
Supposedly, when Fujifilm releases the EF-X500, it brings HSS (finally) to Fujifilm users. I guess the V6 II was released just a tad earlier than Fuji and stole the show (publicly anyway).
Once the EF-X500 comes out we will get one to study how their newborn HSS works and fingerscrossed I hope we can support it as well, on top of our own Forced HSS.
Cactus RF60 would be the no brainer choice for anyone (Canon, Fujifilm, Nikon, Olympus, Panasonic, Pentax and Sony) if they are looking for a dedicated off-camera flash that supports high-speed sync (HSS).
With regards to your comments on both the Quick Start Guide and User Manual to be difficult to follow, please share with us how we can improve.
Thank you very much in advance for your comments!
Brand Manager