Unable to copy learned profile from one V6 to another
I successfully got the V6 to learn a custom profile for an old Sunpak 444D.
Then I tried to copy that learned profile to my other V6s.
Set up the first V6 to transmit and went through the menu to <COPY FLASH SETUP>, then <START>, then <SET RX TO COPY PROFILE>
Set up the other V6s to receive and went through the menu to <FLASH SETUP>, <COPY PROFILE> then <WAITING FOR TX>
Went back to the first V6 and pressed ok for <GO>.
The transmit V6 screen flashes "sending..." then "complete" (or something like that)
The receive V6 just sits there showing "Waiting for TX" without changing then indicates a timeout.
I tried this with multiple receive V6s, with a single receive V6, with the units within 10 cm of each other, with the units about 2 meters apart. No success.
I then got a second V6 to learn the profile of the Sunpak 444D flash with success. Used it as the transmitter to copy to the remaining V6s and still no success.
Is this a problem with the new firmware? I have successfully copied learned profiles before.
Any help would be appreciated. Thanks in advance.