Pentax to multi-brand only allowing single HSS shot without pressing the test button to reset

Using PEN.A.005 on 645Z to V62.A.001 on receivers, cabled to studio packs, I can fire a single shot from the camera when I go above sync speed and into the HSS speed range, and then successive shutter releases don't fire the flash at all. If I send a test flash from the trigger on the camera I can then trigger another HSS release with the shutter, but again only once.

Comments

  • I recommend using the same firmware in both TX and RX unit of the V6 II. Please give it a try.
    Ray Chan

    Senior Product Specialist
     
    Cactus®
    Harvest One Limited
  • I'll try it when I'm back in a week or so, but any of the A firmwares are supposed to be able to trigger any of the others. And since I sometimes use a non-Pentax trigger to fire the flashes it made sense to leave all the receivers running the generic firmware.

    Can you confirm that it should work this way?
Sign In or Register to comment.